get Wind farm noise – what is a reasonable limit in rural areas? | Wind Energy Impacts and Issues

[ exact phrase in "" ]

[ including uploaded files ]


List all documents, ordered…

By Title

By Author

View PDF, DOC, PPT, and XLS files on line
Get weekly updates

Keep Wind Watch online and independent!

Donate $10

Donate $5


Add NWW documents to your site (click here)

Wind farm noise – what is a reasonable limit in rural areas? 

Author:  | Australia, Noise, Regulations


This paper has highlighted that the wind farm noise limits stated in the EPA guidelines (2009) do not ensure adequate protection of the amenity of rural communities. In addition, the concept of zoning has been challenged and background noise levels measured at each residence are proposed as a more suitable method for indicating acceptable noise limits at a given location. A dose response study specific to South Australian rural areas is considered pertinent to provide further guidance for selection of a suitable noise limit. This study should take into account annoying characteristics such as tonality and amplitude modulation, which are not adequately addressed in the EPA guidelines. The potential for background noise sources to mask wind turbine noise up to 5dB louder has also been questioned, particularly with respect to LFN. In addition, a more conservative method of predicting background noise for a given wind speed has been proposed, which is justified by highlighting the inherent difficulties associated with obtaining conclusive compliance measurements. The importance of separating out night-time and daytime background noise measurements for the purpose of establishing acceptable noise wind farm noise levels was also highlighted.

Measurements showed that consideration of the average noise level in a room is more accurate than relying on data from a single transducer. The transmission loss from outside-to-inside was found to be highly dependent on frequency. While the overall transmission loss is close to specifications in the EPA guidelines, in some 1/3 octave bands there is very little difference in noise level from outside-to-inside. The difference in LCeq-LAeq > 20dB suggests that further analysis of the data is required with respect to LFN.

This paper also highlighted the potential inaccuracy of using sound power level data from the manufacturer as an input for sound propagation models where the topography differs significantly from that used in the manufacturer’s measurements. In general, the influence of the surrounding topography on noise generation of wind turbines is not well documented and further research is necessary.

Kristy Hansen, Nicholas Henrys, Colin Hansen, Con Doolan and Danielle Moreau
School of Mechanical Engineering, Adelaide University, Australia

Proceedings of Acoustics 2012—Fremantle, 21-23 November 2012, paper peer reviewed

Download original document: “Wind farm noise – what is a reasonable limit in rural areas?

This material is the work of the author(s) indicated. Any opinions expressed in it are not necessarily those of National Wind Watch.

The copyright of this material resides with the author(s). As part of its noncommercial educational effort to present the environmental, social, scientific, and economic issues of large-scale wind power development to a global audience seeking such information, National Wind Watch endeavors to observe “fair use” as provided for in section 107 of U.S. Copyright Law and similar “fair dealing” provisions of the copyright laws of other nations. Queries e-mail.

Wind Watch relies entirely
on User Funding
Donate $5 PayPal Donate


e-mail X FB LI TG TG Share

Get the Facts
© National Wind Watch, Inc.
Use of copyrighted material adheres to Fair Use.
"Wind Watch" is a registered trademark.


Wind Watch on X Wind Watch on Facebook

Wind Watch on Linked In Wind Watch on Mastodon