Due to standing waves, the sound pressure level within a room may vary as much as 20-30 dB at low frequencies. Principal properties of low-frequency sound in rooms are illustrated by simulations, and sound pressure distributions as well as the performance of Swedish and Danish measurement methods are studied by measurements in three rooms. For assessment of annoyance, mainly areas of the room with high sound pressure levels are of interest, since persons present in such areas are not helped by the existence of lower levels in other areas. The level that is exceeded in 10% of the room (L₁₀) is proposed as a rational and objective target for a measurement method. The Swedish method showed results close to the target, but, due to a doubtful use of C-weighting in the scanning, it may give results below the target in case of complex sounds. The Danish method was found to have a high risk of giving results substantially below the target, unless complainants can precisely appoint measurement positions, where the sound is loudest/most annoying. An alternative method using measurements in four three- dimensional corners of the room is proposed. This easy and straightforward method seems to give reliable results close to the proposed target.
Steffen Pedersen, Henrik Møller, and Kerstin Persson Waye
Section of Acoustics, Department of Electronic Systems, Aalborg University, Aalborg East, Denmark
Journal of Low Frequency Noise, Vibration and Active Control, Vol. 26, No. 4, 2007
Download original document: “Indoor Measurements of Noise at Low Frequencies – Problems and Solutions”
This article is the work of the author(s) indicated. Any opinions expressed in it are not necessarily those of National Wind Watch.
|Wind Watch relies entirely
on User Funding