Documents Home
View PDF, DOC, PPT, and XLS files on line

Add NWW documents to your site (click here)

Sign up for daily updates

Keep Wind Watch online and independent!

Donate $10

Donate $5

News Watch

Selected Documents

Research Links


Press Releases


Publications & Products

Photos & Graphics


Allied Groups


Author:  | Noise, Siting

Choosing the type of wind turbine (WTG) and its exact position are very important parts of the planning work of a wind park. This process is called micrositing.

During micrositing many aspects have to be regarded:

  • wind conditions (statistic data concerning wind speed and wind direction)
  • building requirements (e.g. distances to residences)
  • ownership structure of the area
  • accessibility (existing roads)
  • influence of the WTG on the environment (e.g. shadow flickering, noise emission)
  • distances between the individual turbines in a park

The knowledge of the wind conditions is very important for the decision about the development of a wind park. It is always the best to have measured data of the planned site for a period of at least two years. But this is not always possible. In case of a shorter measurement period wind consultants can find out the conditions by an interpolation of long-term measurements of near-by weather-stations.

Based on the information about the wind conditions it is possible to choose the type of turbine and the park layout which provides the highest energy production while keeping the external requirements. Based on a realistic forecast of the energy production it is possible to decide whether to invest in wind energy or not.

It is important to keep a distance to the next residences in order to not disturb the inhabitants by noise emission and shadow flickering of the turbine. [emphasis added] Normally there have to be at least 500 m [1,640 ft] between the WTG and the next residence.

But it is also very important to keep the distance between the turbines in the park. A layout of a wind farm where the turbines are placed too close to each other could endanger the material and reduce the operating life of the turbines. A rotor of a WTG causes high turbulences that reduce the energy output of the next turbine. Compared with a single stand-alone turbine there are also higher loads on the following turbine because of increased turbulences in the wind park. Therefore the minimum distance between two turbines depends on the wind conditions and may be e.g. 6 rotor diameters (D) in the main wind direction and 4 diameters in other directions. As a matter of principle the turbulence intensities at the WTG should not exceed the certificated turbulence intensities.

The distances between the turbines also have a strong effect on the energy output of the wind park. This effect is described by the park efficiency, the relation between the output of the park and the output of the same number of stand-alone turbines. Therefore the layout has to be planned carefully.

Download original document: “Micrositing

This material is the work of the author(s) indicated. Any opinions expressed in it are not necessarily those of National Wind Watch.

The copyright of this material resides with the author(s). As part of its noncommercial effort to present the environmental, social, scientific, and economic issues of large-scale wind power development to a global audience seeking such information, National Wind Watch endeavors to observe “fair use” as provided for in section 107 of U.S. Copyright Law and similar “fair dealing” provisions of the copyright laws of other nations. Queries e-mail.

Wind Watch relies entirely
on User Funding
Donate $5 PayPal Donate


Get the Facts Follow Wind Watch on Twitter

Wind Watch on Facebook


© National Wind Watch, Inc.
Use of copyrighted material adheres to Fair Use.
"Wind Watch" is a registered trademark.